4 posts
• Page **1** of **1**

This is a pretty basic question but I just wanted to make sure I was calculating P* correctly (P*=(1- (single survey p)^K)). Am I correct in assuming that the single survey p is the Individual Site estimates of p from my model output? Looking at the Blue-lined salamander example it seems so.

- Lea
**Posts:**30**Joined:**Thu Oct 24, 2013 1:09 pm

That is correct for the model where the single-survey p does not change by survey (model p(.)). A more general formula is:

p* = 1 - product( 1-p(j)) {j=1,2,... K}

where p(j) is the detection probability for survey j.

p* = 1 - product( 1-p(j)) {j=1,2,... K}

where p(j) is the detection probability for survey j.

- jhines
**Posts:**408**Joined:**Fri May 16, 2003 9:24 am**Location:**Laurel, MD, USA

Hi Lea,

Note that your initial equation of:

isn't quite correct. It should be

P*=1- (1-p)^K

where p is the single-survey detection probability. Your P* would be the probability of not detecting the species in every survey (i.e., 1 minus the probability of detecting it in every survey), given presence.

Darryl

Note that your initial equation of:

P*=(1- (single survey p)^K)

isn't quite correct. It should be

P*=1- (1-p)^K

where p is the single-survey detection probability. Your P* would be the probability of not detecting the species in every survey (i.e., 1 minus the probability of detecting it in every survey), given presence.

Darryl

- darryl
**Posts:**431**Joined:**Thu Jun 12, 2003 3:04 pm**Location:**Dunedin, New Zealand

4 posts
• Page **1** of **1**

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group. Color scheme by ColorizeIt!